Reference Guide

service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
S4810
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value |
dot1p2 value | dot1p3 value | dot1p4 value| dot1p5 value |
dot1p6 value | dot1p7 value}
Parameters
dot1p0 value ...
dot1p7 value
Enter a dot1p list number and value. The list number range is 0 to 7.
The range is 0 to 3.
Defaults For each dot1p Priority, the default CoS queue value is:
• dot1p Priority: 0 1 2 3 4 5 6 7
• CoS Queue: 0 0 0 1 2 3 3 3
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.
Related
Commands
show qos dot1p-queue-mapping – displays the dot1p priority to queue mapping on the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entries.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic
dot1p
command. The default mapping is as follows:
dot1p E-Series Queue ID C-Series Queue ID S-Series Queue ID
0 2 1 0
1 0 0 0
2 1 0 0
1323