Reference Guide

burst-KB (OPTIONAL) Enter the burst size in KB. The range is 0 to 10000. The
default is 10.
Defaults Granularity for rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
Version 7.6.1.0 Introduced on the S-Series and C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
On 40-port 10G linecards, if the traffic is shaped between 64 and 1000 Kbs, for some values, the
shaped rate is much less than the value configured. Do not use values in this range for 10G
interfaces.
Related
Commands
rate-shape – shapes traffic output as part of the designated policy.
service-class bandwidth-percentage
Specify a minimum bandwidth for queues.
C-Series, S-Series, Z-Series
Syntax
service-class bandwidth-percentage queue0 number queue1 number
queue2 number queue3 number
Parameters
number Enter the bandwidth-weight, as a percentage. The value must be a
power of 2. The range is 1 to 1024.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Guarantee a minimum bandwidth to different queues globally using the service-class
bandwidth-weight command from CONFIGURATION mode. The command is applied in
the same way as the
bandwidth-weight command in an output QoS policy. The
bandwidth-weight command in QOS-POLICY-OUT mode supersedes the service-
class bandwidth-weight
command.
1322