Reference Guide

Without the override option, RPs advertised by the BSR updates take precedence over the
statically configured RPs.
ipv6 pim rp-candidate
Specify an interface as an RP candidate.
E-Series, S4810
Syntax
ipv6 pim rp-candidate interface [priority-value]
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the E-Series, the range
is 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
priority-value (OPTIONAL) Enter a number as the priority of this RP Candidate,
which is included in the Candidate-RP-Advertisements. The range is 0
(highest) to 255 (lowest).
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
ipv6 pim sparse-mode
Enable IPv6 PIM sparse mode on the interface.
E-Series, S4810
Syntax
ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode, use the no ipv6 pim sparse-mode command.
Defaults Disabled.
Command Modes INTERFACE
1279