Reference Guide

ipv6 pim bsr-candidate
Configure the router as a bootstrap (BSR) candidate.
E-Series, S4810
Syntax
ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the no ipv6 pim bsr-candidate command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. For the E-Series, the range
is 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
hash-mask-
length
(OPTIONAL) Enter the hash mask length for RP selection. The range is
0 to 128. The default is 126.
priority (OPTIONAL) Enter the priority value for Bootstrap election process.
The range is 0 to 255. The default is 0.
Defaults Refer to Parameters.
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 7.4.1.0 Introduced
ipv6 pim dr-priority
Change the designated router (DR) priority for the IPv6 interface.
E-Series, S4810
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority
command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The
range is 0 to 4294967294. The default is 1.
1275