Reference Guide

Usage
Information
The following describes the show ip pim tib command shown in the Example below.
Field Description
(S, G) Displays the entry in the multicast PIM database.
uptime Displays the amount of time the entry has been in the PIM route
table.
expires Displays the amount of time until the entry expires and is removed
from the database.
RP Displays the IP address of the RP/source for this entry.
flags List the flags to define the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = FTOS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = first packet from the last hop router is received and the
entry is ready to switch to SPT
• K = acknowledge pending state
Incoming interface Displays the reverse path forwarding (RPF) interface towards the RP/
source.
RPF neighbor Displays the next hop from this interface towards the RP/source.
Outgoing interface
list:
Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group
• statically configured member of the Group
• received a (*,G) Join message
Example
FTOS#show ip pim tib
PIM Multicast Routing Table
Flags:D- Dense, S- Sparse, C- Connected, L- Local, P- Pruned,
R- RP-bit set, F- Register flag, T- SPT-bit set, J- Join
SPT,
M- MSDP created entry, A- Candidate for MSDP
Advertisement,
K- Ack-Pending State
Timers: Uptime/Expires
Interface state: Interface, next-Hop, State/Mode
(*, 226.1.1.1), uptime 01:29:19, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: GigabitEthernet 4/23, RPF neighbor
10.211.1.2
Outgoing interface list:
1272