Reference Guide

38
PIM-Sparse Mode (PIM-SM)
The protocol-independent multicast (PIM) commands are supported by the Dell Force10 operating software (FTOS) on all
E-Series, C-Series, S-Series, Z-Series, or S4810 platforms.
IPv4 PIM-Sparse Mode Commands
The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.
clear ip pim rp-mapping
Used by the bootstrap router (BSR) to remove all or particular rendezvous point (RP) advertisement.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear ip pim rp-mapping rp-address
Parameters
rp-address (OPTIONAL) Enter the RP address in dotted decimal format (A.B.C.D).
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the S-Series.
clear ip pim tib
Clear PIM tree information from the PIM database.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
clear ip pim tib [group]
Parameters
group (OPTIONAL) Enter the multicast group address in dotted decimal
format (A.B.C.D).
Command Modes EXEC Privilege
1251