Reference Guide

Defaults No default behavior or values.
Command Modes
EXEC
Command History
Version 9.1.(0.0) Added support for OSPFv3 on the S4810 and Z9000.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Example
show ipv6 ospf interface command
FTOS#show ipv6 ospf interface gigabitethernet 1/0
GigabitEthernet 1/0 is up, line protocol is up
Link Local Address fe80::201:e8ff:fe17:5bbd, Interface ID
67420217
Area 0, Process ID 1, Instance ID 0, Router ID 11.1.1.1
NetworkType BROADCAST, Cost: 1, Passive: No
Transmit Delay is 100 sec, State DR, Priority 1
Designated router on this network is 11.1.1.1 (local)
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 1,
Retransmit 5
FTOS#
show ipv6 ospf neighbor
Display the OSPF neighbor information on a per-interface basis.
C-Series, E-Series, Z-Series, S4810
Syntax show ipv6 ospf neighbor [interface]
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel
followed by a number:
– C-Series, Z-Series, and S4810 Range: 1 to 128
– E-Series Range: 1 to 255 for TeraScale; 1 to 512 for
ExaScale.
• For a VLAN, enter the keyword vlan followed by the VLAN ID.
Range: 1 to 4094.
1249