Reference Guide

Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Setting a priority of 0 makes the router ineligible for election as a Designated Router or Backup
Designated Router.
Use this command for interfaces connected to multi-access networks, not point-to-point
networks.
ipv6 router ospf
Enable OSPF for IPv6 router configuration.
C-Series, E-Series, Z-Series, S4810
Syntax
ipv6 router ospf process-id
To exit OSPF for IPv6, enter no ipv6 router ospf process-id .
Parameters
process-id
Enter the process identification number.
Range: 1 to 65535.
Defaults No default behavior or values.
Command Modes CONFIGURATION
Command History
Version 9.1.(0.0) Introduced on the S4810 and Z9000.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
maximum-paths
Enable the software to forward packets over multiple paths.
C-Series, E-Series, and S-Series
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths command.
Parameters
number Specify the number of paths. The range is 1 to 64. The default is 8
paths.
Defaults 8
Command Modes ROUTER OSPF
Command History
Version 9.1.(0.0) Introduced.
Version 8.3.11.1 Introduced on the Z9000.
1239