Reference Guide

Items Description
“Adjacency State...” This line displays the adjacency state between neighbors.
Example
FTOS#show ip ospf 1 virt
Virtual Link to router 192.168.253.5 is up
Run as demand circuit
Transit area 0.0.0.1, via interface GigabitEthernet 13/16,
Cost of using 2
Transmit Delay is 1 sec, State POINT_TO_POINT,
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 00:00:02
FTOS#
summary-address
Set the OSPF ASBR to advertise one external route.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
summary-address ip-address mask [not-advertise] [tag tag-value]
To disable summary address, use the no summary-address ip-address mask
command.
Parameters
ip-address Specify the IP address in dotted decimal format of the address to be
summarized.
mask Specify the mask in dotted decimal format of the address to be
summarized.
not-advertise (OPTIONAL) Enter the keywords not-advertise to suppress that
match the network prefix/mask pair.
tag tag-value (OPTIONAL) Enter the keyword tag followed by a value to match on
routes redistributed through a route map. The range is 0 to
4294967295.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
1222