Reference Guide

show ip ospf routes
Display routes as calculated by OSPF and stored in OSPF RIB.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip ospf process-id routes
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information
This command is useful in isolating routing problems between the OSPF and the RTM. For
example, if a route is missing from the RTM/FIB but is visible from the display output of this
command, the problem is with downloading the route to the RTM.
This command has the following limitations:
• The display output is sorted by prefixes; intra-area ECMP routes are not displayed
together.
• For Type 2 external routes, Type 1 cost is not displayed.
Example
FTOS#show ip ospf 100 route
Prefix Cost Nexthop Interface Area Type
1.1.1.1 1 0.0.0.0 Lo 0 0 Intra-Area
3.3.3.3 2 13.0.0.3 Gi 0/47 1 Intra-Area
13.0.0.0 1 0.0.0.0 Gi 0/47 0 Intra-Area
150.150.150.0 2 13.0.0.3 Gi 0/47 - External
172.30.1.0 2 13.0.0.3 Gi 0/47 1 Intra-Area
FTOS#
1215