Reference Guide

link-state-id (OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID
value depends on the LSA type, and it can be one of the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router ip-
address
(OPTIONAL) Enter the keywords adv-router and the ip-address to
display only the LSA information about that router.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show ip ospf process-id database opaque-area
command shown in the Example below.
Item Description
LS Age Displays the LSA’s age.
Options Displays the optional capabilities available on router. The following
options can be found in this item:
• TOS-capability or No TOS-capability is displayed depending
on whether the router can support Type of Service.
• DC or No DC is displayed depending on whether the
originating router can support OSPF over demand circuits.
• E or No E is displayed on whether the originating router can
accept AS External LSAs.
LS Type Displays the LSA’s type.
Link State ID Displays the Link State ID.
Advertising Router Identifies the advertising router’s ID.
Checksum Displays the Fletcher checksum of the an LSA’s complete contents.
Length Displays the length in bytes of the LSA.
Opaque Type Displays the Opaque type field (the first 8 bits of the Link State ID).
1204