Reference Guide

show ip ospf
Display information on the OSPF process configured on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip ospf process-id [vrf vrf name]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
vrf name E-Series Only: Show only the OSPF information tied to the VRF
process.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added output for LSA throttling timers.
Version 8.3.7.0 Introduced on the S4810.
Version 7.9.1.0 Added support for VRF.
Version 7.8.1.0 Added support of Multi-Process OSPF.
Version 7.8.1.0 Added the process-id option, in support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
If you delete all the network area commands for Area 0, the show ip ospf command
output does not list Area 0.
The following describes the show ip ospf command shown in the Example below.
Line Beginning with Description
“Routing Process...” Displays the OSPF process ID and the IP address associated with
the process ID.
“Supports only...” Displays the number of Type of Service (TOS) rouse supported.
“SPF schedule...” Displays the delay and hold time configured for this process ID.
“Convergence
Level”
“Min LSA....” Displays the intervals set for LSA transmission and acceptance.
1193