Reference Guide

Command Modes
• CONFIGURATION
• INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
Usage
Information
The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
FTOS(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
FTOS(conf-if-te-5/0)#
enable
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you may need to enter a
password.
C-Series, E-Series, S-Series, Z-Series
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of FTOS. Range: 0 to
15.
Defaults 15
Command Modes EXEC
118