Reference Guide

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The distribute-list out command applies to routes being redistributed by
autonomous system boundary routers (ASBRs) into OSPF. It can be applied to external type 2
and external type 1 routes, but not to intra-area and inter-area routes.
enable inverse mask
By default, FTOS allows you to input the OSPF network command with a net-mask. This command provides a choice
between inverse-mask or net-mask (the default).
C-Series, E-Series, Z-Series
Syntax
enable inverse mask
To return to the default net-mask, use the no enable inverse mask command.
Defaults net-mask
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route computation so
that convergence takes less time.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
Parameters
number Enter the convergence level desired. The higher this parameter is set,
the faster OSPF converge takes place. The range is 1 to 4.
Defaults none.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
1172