Reference Guide

Field Description
• N + (N-bit is set)
• N - (N-bit is not set)
• MC+ (bit used by MOSPF is set and router is able to forward
IP multicast packets)
• MC- (bit used by MOSPF is not set and router cannot
forward IP multicast packets)
• E + (router is able to accept AS External LSAs)
• E - (router cannot accept AS External LSAs)
• T + (router can support TOS)
• T - (router cannot support TOS)
hi: Displays the amount of time configured for the HELLO interval.
di: Displays the amount of time configured for the DEAD interval.
dr: Displays the IP address of the designated router.
bdr: Displays the IP address of the Border Area Router.
Example
FTOS#debug ip ospf 1 packet
OSPF process 90, packet debugging is on
FTOS#
08:14:24 : OSPF(100:00):
Xmt. v:2 t:1(HELLO) l:44 rid:192.1.1.1
aid:0.0.0.1 chk:0xa098 aut:0 auk: keyid:0 to:Gi 4/3 dst:
224.0.0.5
netmask:255.255.255.0 pri:1 N-, MC-, E+, T-,
hi:10 di:40 dr:90.1.1.1 bdr:0.0.0.0
default-information originate
Configure the FTOS to generate a default external route into an OSPF routing domain.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
default-information originate [always] [metric metric-value]
[metric-type type-value] [route-map map-name]
To return to the default values, use the no default-information originate
command.
Parameters
always (OPTIONAL) Enter the keyword always to specify that default route
information must always be advertised.
metric metric-
value
(OPTIONAL) Enter the keyword metric followed by a number to
configure a metric value for the route. The range is 1 to 16777214.
metric-type type-
value
(OPTIONAL) Enter the keywords metric-type followed by an
OSPF link state type of 1 or 2 for default routes. The values are:
• 1 = Type 1 external route
1166