Reference Guide

Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a
number from zero (0) to 65535.
no-summary (OPTIONAL) Enter the keywords no-summary to prevent the ABR
from sending summary Link State Advertisements (LSAs) into the stub
area.
Defaults Disabled.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Use this command to configure all routers and access servers within a stub.
Related
Commands
router ospf – enters ROUTER OSPF mode to configure an OSPF instance.
area virtual-link
Set a virtual link and its parameters.
C-Series, E-Series, S-Series
Syntax
area area-id virtual-link router-id [[authentication-key
[encryption-type] key] | [message-digest-key keyid md5
[encryption-type] key]] [dead-interval seconds] [hello-interval
seconds] [retransmit-interval seconds] [transmit-delay seconds]
To delete a virtual link, use the no area area-id virtual-link router-id
command.
To delete a parameter of a virtual link, use the no area area-id virtual-link
router-id [[authentication-key [encryption-type] key] |
[message-digest-key keyid md5 [encryption-type] key]] [dead-
interval seconds] [hello-interval seconds] [retransmit-interval
seconds] [transmit-delay seconds] command syntax.
Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a
number from zero (0) to 65535.
router-id Specify an ID (IP address in dotted decimal format) associated with a
virtual link neighbor.
1160