Reference Guide

clear ipv6 mroute
Clear learned multicast routes on the multicast forwarding table. To clear the PIM tib, use the clear ip pim tib
command.
E-Series
Syntax
clear ipv6 mroute {group-address [source-address] | *}
Parameters
group-address
[ source-address ]
Enter multicast group address and source address (if desired) to
clear information on a specific group. Enter the addresses in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
* Enter * to clear all multicast routes.
Defaults none
Command Modes EXEC Privilege
Command History
Version 7.4.1.0 Introduced.
Related
Commands
show ipv6 pim tib – displays the IPv6 PIM tree information base.
debug ipv6 mld_host
Enable the collection of debug information for MLD host transactions.
S4810
Syntax
[no] debug ipv6 mld_host [int-count | interface type] [slot/
port-range]
To discontinue collection of debug information for the MLD host transactions, use the no
debug ipv6 mld_host
command.
Parameters
int-count Enter the keyword count to indicate the number of required debug
messages.
interface type Enter the following keywords and slot/port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port information.
• For a 10G Ethernet interface, enter the keyword
tengigabitethernet followed by the slot/port
information.
• For a 40G interface, enter the keyword fortyGigE followed
by the slot/port information.
1139