Reference Guide

Usage
Information
Static mroutes are used by network administrators to control the reach-ability of the multicast
sources. If a PIM-registered multicast source is reachable using static mroute as well as
unicast route, the distance of each route is examined and the route with shorter distance is the
one the PIM selects for reach-ability.
NOTE: The default distance of mroutes is zero (0) and is CLI configurable on a per route
basis.
Example
FTOS#show ip rpf
RPF information for 10.10.10.9
RPF interface: Gi 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
show queue backplane multicast
Display the backplane bandwidth configuration about how much bandwidth is dedicated to multicast versus unicast.
E-Series
Syntax
show queue backplane multicast bandwidth-percentage
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 7.7.1.0 Introduced on the E-Series.
Example
FTOS#show queue backplane multicast bandwidth-percent
Configured multicast bandwidth percentage is 80
Related
Commands
queue backplane multicast – reallocates the amount of bandwidth dedicated to multicast
traffic.
IPv6 Multicast Commands
The following section contains the IPv6 multicast commands.
1138