Reference Guide

E-Series legacy
command
Related
Commands
show ip mroute – views the E-Series routing table.
ip multicast-lag-hashing
Distribute multicast traffic among port channel members in a round-robin fashion.
E-Series
Syntax
ip multicast-lag-hashing
To revert to the default, use the no ip multicast-lag-hashing command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 6.3.1.0 Introduced on the E-Series.
Usage
Information
By default, one port channel member is chosen to forward multicast traffic. With this feature
turned on, multicast traffic is distributed among the port channel members in a round-robin
fashion. This feature applies to the routed multicast traffic. If you turn on internet group
management protocol (IGMP) snooping, this feature also applies to switched multicast traffic.
Related
Commands
ip multicast-limit – enables IP multicast forwarding.
ip multicast-limit
Use this feature to limit the number of multicast entries on the system.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip multicast-limit limit
Parameters
limit Enter the desired maximum number of multicast entries on the
system. The E-Series range is 50000, the C-Series range is 1 to 10000,
and the S-Series range is 1 to 2000.
Defaults
• E-Series Default: 15000.
• C-Series Default: 4000.
• S-Series Default: 400.
Command Modes CONFIGURATION
Command History
Version 8.3.7.0 Introduced on the S4810.
1131