Reference Guide

Command Modes CONFIGURATION
Command History
Version 9.1.(0.0) Introduced on S4810.
Usage
Information
You must reboot the switch after changing the parameter values for changes to take effect.
Refer to the SDN chapter in the FTOS Configuration Guide for platform-specific instructions on
using this command.
cam-audit linecard
Enable audit of the IPv4 forwarding table on all line cards.
E-Series
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
all Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on the
IPv4 forwarding entries.
interval time-in-
minutes
Enter the keyword interval followed by the frequency in minutes
of the CAM audit. Range: 5 to 1440 minutes (24 hours). Default: 60
minutes.
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Enables periodic audits of the software and hardware copies of the IPv4 forwarding table.
clear alarms
Clear alarms on the system.
C-Series, E-Series, S-Series, Z-Series
Syntax
clear alarms
Command Modes EXEC Privilege
113