Reference Guide

Multicast

The multicast commands are supported by FTOS on all E-Series, C-Series, S-Series, Z-Series, or S4810 Dell Force10

platforms.

This chapter contains the following sections:

• IPv4 Multicast Commands

• IPv6 Multicast Commands

IPv4 Multicast Commands

The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree

information base, use the

clear ip pim tib command.

C-Series, E-Series, S-Series, Z-Series, S4810

Syntax

clear ip mroute {group-address [source-address] | *}

Parameters

group-address

[

source-address

]

Enter the multicast group address and source address (if desired), in

dotted decimal format, to clear information on a specific group.

* Enter * to clear all multicast routes.

Command Modes EXEC Privilege

Command History

Version 8.3.7.0 Introduced on the S4810.

Version 7.8.1.0 Introduced on the C-Series.

E-Series legacy

command

Commands

show ip pim tib – shows the PIM tree information base.

1129