Reference Guide

l2acl number
ipv4acl number
ipv6acl number ,
ipv4qos number
l2qos number ,
l2pt number
ipmacacl number
ecfmacl number
[vman-qos |
vman-dual-qos
number
Allocate space to each CAM region.
Enter the CAM profile name followed by the amount of CAM space to
be allotted. The total space allocated must equal 13. The ipv6acl
range must be a factor of 2.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run
start
) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three blocks and
these cannot be reallocated. The ipv4acl profile range is 1 to 4.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are 1 to 10, except for the ipv6acl profile which is 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
S4810
Syntax
cam-acl-vlan vlanopenflow {0|1} vlaniscsi {0|1}
Defaults Disabled.
Parameters
vlanopenflow Enter the number 1 to allocate VFP blocks and enable OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
vlaniscsi Enter the number 1 to allocate VFP blocks for iSCSI.
Enter the number 0 to disable iSCSI CAM allocation.
112