Reference Guide

ip msdp log-adjacency-changes
Enable logging of MSDP adjacency changes.
E-Series, Z-Series, S4810
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
ip msdp mesh-group
Configure a peer to be a member of a mesh group.
E-Series, Z-Series, S4810
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group {name}
{peer address} command.
Parameters
name Enter a string of up to 16 characters long for as the mesh group name.
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.2.1.1 Introduced
Usage
Information
A MSDP mesh group is a mechanism for reducing SA flooding, typically in an intra-domain
setting. When some subset of a domain’s MSDP speakers are fully meshed, they can be
configured into a mesh-group. If member X of a mesh-group receives a SA message from an
MSDP peer that is also a member of the mesh-group, member X accepts the SA message and
1103