Reference Guide

Related
Commands
debug lldp interface – debugs LLDP.
show lldp neighbors – displays the LLDP neighbors.
show running-config lldp – displays the LLDP running configuration.
advertise med power-via-mdi
Configure the system to advertise the Extended Power via MDI TLV.
C-Series, S-Series, S4810
Syntax
advertise med power-via-mdi
To return to the default, use the no advertise med power-via-mdi command.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Usage
Information
Advertise the Extended Power via MDI on all ports that are connected to an 802.3af powered,
LLDP-MED endpoint device.
Related
Commands
debug lldp interface – debugs LLDP.
show lldp neighbors – displays the LLDP neighbors.
show running-config lldp – displays the LLDP running configuration.
advertise med softphone-voice
Configure the system to advertise softphone to enable IP telephony on a computer so that the computer can be used as
a phone.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
advertise med softphone-voice {vlan-id layer2_priority
DSCP_value} | {priority-tagged number}
To return to the default, use the no advertise med softphone-voice {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is 1 to 4094.
layer2_priority Enter the Layer 2 priority (C-Series and E-Series only). The range is 0
to 7.
DSCP_value Enter the DSCP value (C-Series and E-Series only). The range is 0 to
63.
1093