Reference Guide

Version 7.4.1.0 Introduced on the E-Series.
mode
Set LLDP to receive or transmit.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
Parameters
tx Enter the keyword tx to set the mode to transmit.
rx Enter the keyword rx to set the mode to receive.
Defaults Both transmit and receive.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
protocol lldp (Configuration) – enables LLDP globally.
show lldp neighbors – displays the LLDP neighbors.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer Enter the number of consecutive misses before the LLDP declares the
interface dead. The range is 2 to 10.
Defaults 4 x hello
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
1086