Reference Guide

disable
Enable or disable LLDP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
protocol lldp (Configuration) – enables LLDP globally.
debug lldp interface – debugs LLDP.
show lldp neighbors – displays the LLDP neighbors.
show running-config lldp – displays the LLDP running configuration.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are sent to its
peer. The rate is 5 to 180 seconds. The default is 30 seconds.
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
1085