Reference Guide

disabled” state, you must enter the fefd reset command to reset
the interface state.
Defaults normal
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Legacy E-Series
command.
Related
Commands
• fefd – enables far-end failure detection.
fefd reset
Reset all interfaces or a single interface that was in “error-disabled” mode.
E-Series, Z-Series, S4810
Syntax
fefd reset [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/ port information.
Defaults Not configured.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.12.0 Introduced on the S4810.
Legacy E-Series
command.
Related
Commands
• fefd – enables far-end failure detection.
1075