Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4810P

1071

Commands

• fefd – enables far-end failure detection on an interface.

• fefd reset – enables FEFD globally on the system.

fefd

Enable far-end failure detection on an interface.

E-Series, Z-Series, S4810

Syntax

fefd

To disable FEFD on an interface, use the no fefd command.

Defaults Disabled.

Command Modes INTERFACE

Command History

Version 8.3.11.1 Introduced on the Z9000.

Version 8.3.12.0 Introduced on the S4810.

Legacy E-Series

command.

Usage

Information

When you enter no fefd for an interface and fefd-global, FEFD is enabled on the interface

because the no fefd command is not retained in the configuration file. To keep the interface

FEFD disabled when the global configuration changes, use the fefd reset command.

Commands

• fefd disable – disables far-end failure detection on an interface.

• fefd reset – enables FEFD globally on the system.

• fefd mode – changes FEFD mode on an interface.

fefd disable

Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.

E-Series, S4810