Reference Guide

dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch.
static (OPTIONAL) Enter the keyword static to display only those MAC
address specifically configured on the switch.
interface
interface
(OPTIONAL) Enter the keyword interface followed by the
interface type, slot and port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the S-Series, the range
is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1 to
4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
show mac-address-table
Display the MAC address table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show mac-address-table [dynamic | static] [address mac-address
| interface interface | vlan vlan-id] [count [vlan vlan-id]
[interface interface-type [slot [/port]]]]
Parameters
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch. Optionally, you can
also add one of these combinations: address/mac-address,
interface/interface, or vlan vlan-id.
static (OPTIONAL) Enter the keyword static to display only those MAC
address specifically configured on the switch. Optionally, you can
also add one of these combinations: address/mac-address,
interface/interface, or vlan vlan-id.
1054