Reference Guide

Command History
Version 8.3.7.0 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
For information about the specific trap sent and the corresponding Syslog, refer to the SNMP
Traps chapter.
mac-address-table station-move time-interval
Reduce the amount of time FTOS takes to detect aged entries and station moves.
E-Series
Syntax
[no] mac-address-table station-move time-interval number
Parameters
time-interval
number
Select the interval of the successive scans of the MAC address table
that are used to detect a aged entries and station moves. The range is
500 to 5000 ms.
Defaults 5000 ms
Command Modes CONFIGURATION
Command History
Version 7.8.1.0 Introduced on the E-Series.
Usage
Information
FTOS takes four to five seconds to detect aged entries and station moves because the MAC
address table scanning routine runs every 5000 ms by default. To achieve faster detection,
reduce the scanning interval.
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a
topology change.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
1044