Reference Guide

Example
The bold section below identifies that Multi-Topology IS-IS is enabled.
FTOS#show isis protocol
IS-IS Router: <Null Tag>
System Id: F100.E120.0013 IS-Type: level-1-2
Manual area address(es):
49.0000.0001
Routing for area address(es):
49.0000.0001
Interfaces supported by IS-IS:
GigabitEthernet 1/0 - IP - IPv6
GigabitEthernet 1/1 - IP - IPv6
GigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
FTOS#
show isis traffic
This command allows you to display IS-IS traffic interface information.
E-Series, S4810
Syntax
show isis traffic [interface]
Parameters
interface (OPTIONAL) Identifies the interface type slot/port as one of the
following:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
1027