Reference Guide

set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
Example
(Address-
Family_IPv6)
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
FTOS(conf-router_isis-af_ipv6)#show conf
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
show isis database
Display the IS-IS link state database.
E-Series, S4810
Syntax
show isis database [level-1 | level-2] [local] [detail |
summary] [lspid]
Parameters
level-1 (OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2 (OPTIONAL) Displays the Level 2 IS-IS link-state database.
local (OPTIONAL) Displays local link-state database information.
detail (OPTIONAL) Detailed link-state database information of each LSP
displays when specified. If not specified, a summary displays.
summary (OPTIONAL) Summary of link-state database information displays
when specified.
lspid (OPTIONAL) Display only the specified LSP.
Command Modes
• EXEC
• EXEC Privilege
Usage
Information
The following describes the show isis database command shown in the Example
below.
Field
Description
IS-IS Level-1/Level-2
Link State Database
Displays the IS-IS link state database for Level 1 or Level 2.
1020