Concept Guide

• neighbor advertisement-interval
• neighbor distribute-list out
• neighbor filter-list out
• neighbor next-hop-self
• neighbor route-map out
• neighbor route-reflector-client
• neighbor send-community
A neighbor may keep its conguration after it was added to a peer group if the neighbor’s conguration is more specic than the peer
group’s and if the neighbor’s conguration does not aect outgoing updates.
NOTE: When you congure a new set of BGP policies for a peer group, always reset the peer group by entering the clear ip
bgp peer-group peer-group-name command in EXEC Privilege mode.
To view the
conguration, use the show config command in CONFIGURATION ROUTER BGP mode.
When you create a peer group, it is disabled (shutdown). The following example shows the creation of a peer group (zanzibar) (in bold). To
enable a peer group, use the neighbor peer-group-name no shutdown command.
DellEMC(conf)# router bgp 45
DellEMC(conf-router_bgp)#neighbor zanzibar peer-group
DellEMC(conf-router_bgp)# neighbor zanzibar no shutdown
DellEMC(conf-router_bgp)# neighbor 10.1.1.1 remote-as 65535
DellEMC(conf-router_bgp)# neighbor 10.1.1.1 no shutdown
DellEMC(conf-router_bgp)# neighbor 10.14.8.60 remote-as 18505
DellEMC(conf-router_bgp)# neighbor 10.14.8.60 no shutdown
DellEMC(conf-router_bgp)# neighbor 2001::1/64 peer-group zanzibar
Following is the show config output for the above sample conguration.
DellEMC# show config
!
router bgp 45
neighbor zanzibar peer-group
neighbor zanzibar no shutdown
neighbor 10.1.1.1 remote-as 65535
neighbor 10.1.1.1 shutdown
neighbor 10.14.8.60 remote-as 18505
neighbor 10.14.8.60 no shutdown
neighbor 2001::1/64 peer-group zanzibar
DellEMC#
To disable a peer group, use the neighbor peer-group-name shutdown command in CONFIGURATION-ROUTER-BGP mode. The
conguration of the peer group is maintained, but it is not applied to the peer group members. When you disable a peer group, all the peers
within the peer group that are in the ESTABLISHED state move to the IDLE state.
To view the status of peer groups, use the show ip bgp peer-group command in EXEC Privilege mode, as shown in the following
example.
DellEMC>show ip bgp peer-group
Peer-group zanzibar
BGP version 4
Minimum time between advertisement runs is 5 seconds
For address family: IPv4 Unicast
BGP neighbor is zanzibar, peer-group internal,
Number of peers in this group 1
Peer-group members (* - outbound optimized):
2001::1/64
200
BGP IP version 4 (BGPv4) Overview