Reference Guide

Parameters
seconds Enter the rate, in seconds, at which the control packets are sent to its
peer. The rate is from 5 to 180 seconds. The default is 30 seconds.
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
management-interface
Enable and configure LLDP protocol parameters on the management interface.
S4810
Syntax
management-interface
To remove LLDP configuration on a management interface, use the no management-
interface
command.
Command Modes LLDP (conf-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Introduced on the Z9000 and S4810.
Usage
Information
To enable LLDP on the management interface, use the no disable command in LLDP-
MANAGEMENT-INTERFACE mode (conf-lldp-mgmtIf).
mode
To receive or transmit, set LLDP.
S4810
Syntax
mode {tx | rx}
To return to the default, use the no mode {tx | rx} command.
978