Reference Guide

If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
If you do not configure the default-metric command, in addition to the redistribute
command, or there is no route map to set the metric, the metric for redistributed static and
connected is “0”.
To redistribute the default route (0::0/0), configure the neighbor default-
originate command.
Related
Commands
neighbor default-originate – injects the default route.
redistribute isis
Redistribute IS-IS routes into BGP.
S4810
Syntax
redistribute isis [level-1 | level-1-2 | level-2] [metric
metric-value | metric-type {external | internal}] [route-map
map-name]
To stop redistribution of IS-IS routes, use the no redistribute isis command.
Parameters
level-1 | level-1-2
| level-2]
(OPTIONAL) Enter the type (level) of routes to redistribute.
metric (OPTIONAL) Assign metric to an interface for use with IPv6
information.
metric-type (OPTIONAL) The external link type associated with the default route
advertised into a routing domain. You must specify one of the
following:
• external
803