Reference Guide

Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix length in
the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Though the system does not generate a route due to backdoor config, there is an option for
injecting/ sourcing a local route in presence of network backdoor config on a learned route.
redistribute
Redistribute routes into BGP.
S4810
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected Enter the keyword connected to redistribute routes from physically
connected interfaces.
static Enter the keyword static to redistribute manually configured
routes. These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
802