Reference Guide

mask Enter the mask of the IP address in the slash prefix length format (for
example, /24). The mask appears in command outputs in dotted
decimal format (A.B.C.D).
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The software resolves the network address configured by the network command with the
routes in the main routing table to ensure that the networks are reachable using non-BGP
routes and non-default routes.
Related
Commands
redistribute – redistributes routes into BGP.
network backdoor
Specify this IGP route as the preferred route.
S4810
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length
backdoor command.
801