Reference Guide

permit ^\(.*\)$
FTOS#
IP Community List Commands
IP community list commands are supported on the S4810 platform.
ip community-list
Enter COMMUNITY-LIST mode and create an IP community-list for BGP.
S4810
Syntax
ip community-list comm-list-name
To delete a community-list, use the no ip community-list comm-list-name
command.
Parameters
comm-list-name Enter a text string as the name of the community-list, up to 140
characters.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
pre-Version
6.1.1.0
Introduced on the E-Series.
Example
FTOS(conf)#ip community-list TestComList
FTOS(config-community-list)#
show ip community-lists
Display configured IP community lists in alphabetic order.
S4810
Syntax
show ip community-lists [name]
263