Reference Guide

Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
ip community-list — configures community access list.
match community — redistributes routes that match the COMMUNITY attribute.
neighbor send-community — assigns the COMMUNITY attribute.
show ip bgp community — displays BGP community groups.
show ip community-lists — displays configured Community access lists.
set level
To specify the IS-IS level or OSPF area to which matched routes are redistributed, configure a filter.
S4810
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-
area}
To remove a set level condition, use the no set level {backbone | level-1 |
level-1-2 | level-2 | stub-area}
command.
Parameters
backbone Enter the keyword backbone to redistribute matched routes to the
OSPF backbone area (area 0.0.0.0).
level-1 Enter the keyword level-1 to redistribute matched routes to IS-IS
Level 1.
level-1-2 Enter the keyword level-1-2 to redistribute matched routes to IS-
IS Level 1 and Level 2.
level-2 Enter the keyword level-2 to redistribute matched routes to IS-IS
Level 2.
stub-area Enter the keyword stub to redistributed matched routes to OSPF
stub areas.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
253