Reference Guide

dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP
values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for
the ACL entry. The range is from 0 to 254 (where 0 is the highest
priority and 254 is the lowest; lower-order numbers have a higher
priority). If you do not use the keyword
order, the ACLs have the
lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Add the DSCP value for ACL matching.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
Version 6.5.10 Expanded to include the optional QoS order priority for the ACL
entry.
Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For more
information, refer to the “Quality of Service” chapter of the
FTOS Configuration Guide .
The software cannot count both packets and bytes; when you enter the count byte options,
only bytes are incremented.
Related
Commands
ip access-list extended — creates an extended ACL.
permit tcp — assigns a permit filter for TCP packets.
permit udp — assigns a permit filter for UDP packets.
206