Reference Guide

Usage
Information
By default, all VLANs are mapped to MST instance zero (0) unless you use the vlan range
command to map it to a non-zero instance.
name
The name you assign to the multiple spanning tree region.
S4810
Syntax
name region-name
To remove the region name, use the no name command.
Parameters
region-name Enter the MST region name. The range is 32 character limit.
Defaults no default name.
Command Modes MULTIPLE SPANNING TREE
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced.
Usage
Information
For two MSTP switches to be within the same MSTP region, the switches must share the same
region name (including matching case).
Related
Commands
msti — maps the VLAN(s) to an MST instance.
revision — assigns the revision number to the MST configuration.
1012