Reference Guide

ip msdp sa-filter
Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the specified peer.
S4810
Syntax
ip msdp sa-filter {in | out} peer-address list [access-list
name]
Remove this configuration using the no ip msdp sa-filter {in | out} peer
address list [access-list name] command.
Parameters
in Enter the keyword in to enable incoming SA filtering.
out Enter the keyword out to enable outgoing SA filtering.
peer-address Enter the peer address of the MSDP peer in a dotted decimal format
(A.B.C.D.).
access-list name Enter the name of an extended ACL that contains permitted SAs. If
you do not use this option, all local entries are blocked.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the E-Series.
ip msdp sa-limit
Configure the upper limit of source-active (SA) entries in SA-cache.
S4810
Syntax
ip msdp sa-limit number
To return to the default, use the no ip msdp sa-limit number command.
Parameters
number Enter the maximum number of SA entries in SA-cache. The range is
from 0 to 40000.
1002