Reference Guide

You can create multiple instances of this route map by using the sequence number option to place the route maps in
the correct order. FTOS processes the route maps with the lowest sequence number first. When a configured route map
is applied to a command, such as redistribute, traffic passes through all instances of that route map until a match
is found. The following is an example with two instances of a route map.
Example of Matching Instances of a Route-Map
FTOS#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
FTOS#
To delete all instances of that route map, use the no route-map map-name command. To delete just one instance,
add the sequence number to the command syntax.
Example of Deleting Instances of a Route Map
FTOS(conf)#no route-map zakho 10
FTOS(conf)#end
FTOS#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
FTOS#
The following example shows a route map with multiple instances. The show config command displays only the
configuration of the current route map instance. To view all instances of a specific route map, use the
show route-
map command.
Example of Viewing All Instances of a Specified Route Map
FTOS#show route-map dilling
route-map dilling, permit, sequence 10
Match clauses:
Set clauses:
route-map dilling, permit, sequence 15
Match clauses:
interface Loopback 23
Set clauses:
tag 3444
FTOS#
To delete a route map, use the no route-map map-name command in CONFIGURATION mode.
Configure Route Map Filters
Within ROUTE-MAP mode, there are match and set commands.
• match commands search for a certain criterion in the routes.
• set commands change the characteristics of routes, either adding something or specifying a level.
101