Users Guide

cam-acl (Configuration)
Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and
Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet Connectivity
Fault Management (CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
S4810
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos
number l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos
number] ecfmacl number [nlbclusteracl number] ipv4pbr number }openflow
number | fcoe number} [iscsioptacl number] [vrfv4acl number]
Parameters
default Use the default CAM profile settings and set the CAM as follows:
● L2Acl : 6
● IPV4Acl : 4
● IPV6Acl : 0
● IPV4Qos : 2
● L2Qos : 1
● L2PT : 0
● IpMacAcl : 0
● VmanQos : 0
● VmanDualQos : 0
● EcfmAcl : 0
● nlbclusteracl: 0
● FcoeAcl : 0
● iscsiOptAcl : 0
● ipv4pbr : 0
● vrfv4Acl :0
● Openflow : 0
● fedgovacl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 1
to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4. The range
is from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6. The range
is from 0 to 4.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4. The
range is from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks for l2 qos. The range
is from 1 to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol
tunnelling. The range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC
ACL. The range is from 0 to 6.
ecfmacl number Enter the keyword ecfmacacl and then the number of FP blocks for ECFM ACL.
The range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP blocks for
nlbcluster ACL. The range is from 0 to 2. By default, the value is 0 and it supports 8
NLB arp entries reserved for internal functionality.
NOTE: When you reconfigure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is
410 Content Addressable Memory (CAM)