Reference Guide

802 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.
neighbor route-reflector-client
c e
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor {ipv6-address | peer-group-name} route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector
configuration, use the
no neighbor {ipv6-address | peer-group-name} route-reflector-client
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all
routes).
in
Enter the keyword in to filter inbound routes.
out
Enter the keyword out to filter outbound routes.
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Version 8.4.2.1 Introduced on C-Series and S4810