Reference Guide

78 | Control and Monitoring
www.dell.com | support.dell.com
exec-banner
c e s
Enable the display of a text string when the user enters the EXEC mode.
Syntax
exec-banner
Defaults
Enabled on all lines (if configured, the banner appears).
Command Modes
LINE
Command
History
Usage
Optionally, use the banner exec command to create a text string that is displayed when the
user accesses the EXEC mode. This command toggles that display.
Related
Commands
exec-timeout
ce s
Set a time interval the system will wait for input on a line before disconnecting the session.
Syntax
exec-timeout minutes [seconds]
To return to default settings, enter
no exec-timeout.
Parameters
Defaults
10 minutes for console line; 30 minutes for VTY lines; 0 seconds
Command Modes
LINE
Note: For E-Series ExaScale, the 2.4 setting is supported on FTOS version 8.3.1.0
and later. The 10.4 setting is supported on all ExaScale FTOS versions. The 3.2
setting is only supported on FTOS versions 8.2.1.0 and earlier.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
banner exec Configure a banner to display when entering the EXEC mode.
line Enable and configure console and virtual terminal lines to the system.
minutes Enter the number of minutes of inactivity on the system before disconnecting the
current session.
Range: 0 to 35791
Default: 10 minutes for console line; 30 minutes for VTY line.
seconds (OPTIONAL) Enter the number of seconds
Range: 0 to 2147483
Default: 0 seconds