Reference Guide

76 | Control and Monitoring
www.dell.com | support.dell.com
Usage
Information
The default interval for the polling is 300 seconds (5 minutes). Use this command to enable
the polling and to configure the polling frequency.
enable xfp-power-updates
c e s
Enable XFP power updates for SNMP.
Syntax
enable xfp-power-updates interval seconds
To disable XFP power updates, use the no enable xfp-power-updates command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
The chassis MIB contain the entry chSysXfpRecvPower in the chSysPortTable table.
Periodically, IFA polls the XFP power for each of the ports, and sends the values to IFM
where it is cached. The default interval for the polling is 300 seconds (5 minutes). Use this
command to enable the polling and to configure the polling frequency.
end
c e s
Return to the EXEC Privilege mode from other command modes (for example, the
CONFIGURATION or ROUTER OSPF modes).
Syntax
end
Command Modes
CONFIGURATION, SPANNING TREE, MULTIPLE SPANNING TREE, LINE,
INTERFACE, TRACE-LIST, VRRP, ACCESS-LIST, PREFIX-LIST, AS-PATH ACL,
COMMUNITY-LIST, ROUTER OSPF, ROUTER RIP, ROUTER ISIS, ROUTER BGP
Command
History
interval seconds
Enter the keyword interval followed by the polling interval in seconds.
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)
Version 8.3.10.0 Deprecated command for S4810 only. Replaced by the enable
optic-info-update interval
command to update information on
temperature and power monitoring in the SNMP MIB.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series