Reference Guide

734 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port |
Status
------------------------------------------------------------------------------
------------
4 | 0 | IPv4Flow | 232 | 0 |
Allowed
4 | 0 | IPv6Flow | 0 | 0 |
Allowed
FTOS#
FTOS#test cam-usage service-policy input LauraMapTest linecard 2 port-set 1
Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port |
Status
------------------------------------------------------------------------------
------------
2 | 1 | IPv4Flow | 232 | 0 |
Allowed
2 | 1 | IPv6Flow | 0 | 0 |
Allowed
FTOS#)
IPv6 Route Map Commands
The following commands allow you to configure route maps and their redistribution criteria.
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• route-map
• set ipv6 next-hop
• show config
• show route-map
match ipv6 address
Table 24-3. Output Explanations: test cam-usage
Term Explanation
Linecard Lists the line card or linecards that are checked. Entering all
shows the status for linecards in the chassis
Portpipe Lists the portpipe (port-set) or port pipes (port-sets) that are
checked. Entering all shows the status for linecards and
port-pipes in the chassis.
CAM Partition Shows the CAM profile of the CAM
Available CAM Identifies the amount of CAM space remaining for that profile
Estimated CAM per Port Estimates the amount of CAM space the listed policy will
require.
Status Indicates whether or not the policy will be allowed in the
CAM