Reference Guide

576 | Interfaces
www.dell.com | support.dell.com
Related
Commands
ecmp-group
Provides a mechanism to monitor traffic distribution on a LAG link bundle. A system log or
SNMP trap is generated when the standard deviation of traffic distribution on a member link
exceeds a defined threshold.
Syntax
ecmp-group {ecmp-path} [interface interface] [monitoring enable]
To negate a command, use the
no command.
Parameters
Defaults
Off
Command Modes
CONFIGURATION
Command
History
flowcontrol
c e s
Control how the system responds to and generates 802.3x pause frames on 1Gig and 10Gig
line cards.
Syntax
flowcontrol rx {off | on} tx {off | on} threshold {<1-2047> <1-2013> <1-2013>}
The
threshold keyword is supported on C-Series and S-Series only.
Parameters
speed (for 10/100/1000 interfaces) Set the speed on the Base-T Ethernet interface.
negotiation auto Enable or disable auto-negotiation on an interface.
ecmp-path
Enter the path number for the LAG.
Range: 2 to 64
interface
Enter the following keywords and slot/port to add the interface to the
LAG.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
monitoring
Enter the keyword monitoring to monitor the LAG. To enable
monitoring, follow by entering the keyword enable.
Version 8.3.10.0 Introduced on S4810
rx on
Enter the keywords rx on to process the received flow control frames on this port.
This is the default value for the receive side.
rx off
Enter the keywords rx off to ignore the received flow control frames on this port.