Reference Guide

552 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
Command Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
Usage
Information
The access list accepted is an extended ACL. This feature is used to block IGMP reports from
hosts, on a per-interface basis; based on the group address and source address specified in the
access list.
ip igmp group-join-limit
c e s
Use this feature to limit the number of IGMP groups that can be joined in a second.
Syntax
ip igmp group-join-limit number
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-if-interface-slot/port)
Command
History
ip igmp immediate-leave
c e s
Enable IGMP immediate leave.
Syntax
ip igmp immediate-leave
[group-list prefix-list-name]
To disable ip igmp immediate leave, use the
no ip igmp immediate-leave command.
Parameters
Defaults
Not configured
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced on E-Series
number
Enter the number of IGMP groups permitted to join in a second.
Range: 1 to 10000
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced on E-Series
group-list prefix-list-name
Enter the keyword group-list followed by a string up to
16 characters long of the prefix-list-name.